: New firmware version 1.0.5.1 is available for EOS C70 : Help ensure your autofocus is properly aligned with a Canon Precision Alignment : New firmware version 1.0.3.1 is available for EOS-R5 C : New firmware version 1.4.1 is available for EOS R3 This takes about 1 to 2 minutes.Īfter performing a few cleanings, please print another test page. The cleaning will be complete when the ON lamp lights green after flashing.ĭo not perform any other operations until the machine completes the cleaning of the print head. The machine starts cleaning the print head. Hold down the STOP button until the Alarm lamp flashes orange twice, then release it immediately.Ģ. If the test page does not match the example attached to this email, printhead cleanings should be performed.

Please compare the test page that you printed with the one that has been attached to the bottom of this post. The nozzle check pattern will be printed. Hold down the STOP button until the Alarm lamp flashes once, then release it immediately. Open the output tray extension, open the paper output tray, then extend the paper output support.Ĥ. Load a sheet of A4 or Letter-sized plain paper in the front tray.ģ. Make sure that your PIXMA MG3620 is turned on.Ģ. The nozzle check pattern shows if each print head nozzle is operating properly. A test page from your PIXMA MG3620 should be printed.

Canon printer will only print test page